The area has been paused, normally occurring via the administrator operating virsh suspend. The domain is not running. To further filter the checklist of domains you may specify one or more of filtering flags supported by the record command. The area has crashed, which is all the time a violent ending. When in a paused state the domain will still consume allotted assets like reminiscence, but will not be eligible for scheduling by the hypervisor. To checklist inactive domains specify –inactive or –all to checklist both lively and inactive domains. The area is in the strategy of shutting down, i.e. the guest operating system has been notified and should be within the technique of stopping its operations gracefully. Normally only energetic domains are listed. The domain has been suspended by guest power administration, e.g. entered into s3 state. Usually this state can only happen if the domain has been configured to not restart on crash. Usually this signifies the area has been shut down utterly, or has not been began.
However, if –wait is specified, then this command will block until the operation completes (or for –energetic, enters the second part), or until the operation is canceled as a result of the elective timeout in seconds elapses or SIGINT is sent (often with Ctrl-C). Copy a disk backing image chain to a destination. If job cancellation is triggered, –async will return control to the consumer as fast as possible, in any other case the command may proceed to dam a short while longer till the job is finished cleansing up. For further information on the bandwidth argument see the corresponding section for the blockjob command. Using –verbose together with –wait will produce periodic standing updates. MiB/s, though for Texas Pool Tech QEMU, it could also be non-zero only for an online domain. Using –pivot is shorthand for combining –lively –wait with an computerized blockjob –pivot; and using –keep-overlay is shorthand for combining –active –wait with an automatic blockjob –abort. Either dest because the destination file identify, Premier Pools & Spas or –xml with the identify of an XML file containing a high-stage component describing the destination, have to be present.
MiB/s. Specifying a unfavorable value is interpreted as an unsigned lengthy lengthy value that is likely to be basically limitless, however extra possible would overflow; it is safer to use zero for that objective. If –async can be specified, this command will return immediately, reasonably than ready for the cancellation to complete. For further information on the bandwidth argument see the corresponding part for the blockjob command. VM crashes or is turned off before the job completes. There are three mutually-unique modes: –data, bandwidth, and –abort. In –abort mode, the active job on the required disk can be aborted. If –pivot is specified, this requests that an energetic copy or active commit job be pivoted over to the new picture. Manage lively block operations. If –print-xml is specified, then the XML used to start out the block copy job is printed instead of starting the job. This flag removes the restriction of copy jobs to transient domains if that restriction is utilized by the hypervisor.
If –dwell is specified, have an effect on a working area. If –reside is specified, have an effect on a operating domain. For compatibility functions, –persistent behaves like –config for an offline domain, and like –dwell –config for a working area. Note that older versions of virsh used –config as an alias for –persistent. Both –live and –config flags could also be given, however –current is unique. Both –live and –config flags may be given, but –current is exclusive. If –current is specified, it’s equal to both –stay or –config, relying on the current state of the guest. If –current is specified, it’s equivalent to both –reside or –config, relying on the present state of the guest. Detach a disk device from a domain. If –config is specified, Liberty Hill Pool Service have an effect on the following startup of a persistent visitor. When no flag is specified legacy API is used whose conduct is dependent upon the hypervisor driver. If –config is specified, Author Profile have an effect on the subsequent startup of a persistent visitor. The target is the gadget as seen from the area.